1.50 Inch Pie Cutting jig
This jig is cutting straight tube into pie cut sections to then make custom bends for those tight and intricate jobs, or to show off your skills in fabrication and welding, these jigs will enable the ease of cutting and repeating for as many pieces as needed.
The jig will fit inside the clamp of the saw, it uses the compression from the clamp to then grab hold of the tube. Adjust the angle of the blade to match the jig and its ready to go.
Model is printed in PETG.
3 colors to choose from: Black, Orange and White.
Outer Diameter – 1.50 Inch(38.1mm)
Available in the below pie angles:
9Degree
15Degree
Product Usage Instructions
- Use the calculator to work out how far out the tube needs to protrude from the jig.
- Fit the tube into the jig, then into clamp on the saw, make sure the angled cut slides up to the blade
- Tighten the clamp down so it is just gripping the tube, adjust the amount of material to be removed to get your first angle, make the first cut, the piece that was removed will make up for the first cut.
- To cut the first pie section, loosen the clamp, and then roll the tube 180 degrees, adjust the tube to protrude enough for the desired bend CLR from the calculator also take into to account the thickness of the blade. Tighten the clamp and make the next cut, repeat this for the desired amount of pie cuts.
£13.21Price
